Reader Question Dear Austin, I am in the process of trying to replace the ignition module in a 1992 S10 but I can’t figure out how to remove to rotor. I am asking for this advice because I don’t want to cause more problems by breaking the rotor. I can’t see any thing that is holding thr rotor but I can’t get it to budge. Thanks for any advice you can give, thanks, Don

Hi Don

You should just pull up on the ignition rotor. You might have to wiggle it from side to side if it is stuck or rusted on.

Blessings,

Austin C. Davis

Related posts:

  1. 1991 Chevy S 10 Pick Up Won’t Start – No Spark or Fuel
  2. Renault Espace Engine Misfire – Spark Plugs – Wire and Ignition Coil are new
  3. My 1975 Chevy Camaro Needs a New Engine What Do You Suggest?
  4. 1992 Buick Riviera Dies While I am Driving and I Have to Wait 10 Minutes to Restart
  5. New Orleans News – How Much To Remove The Flood Damaged Cars?

Filed under: Reader Questions

Like this post? Subscribe to my RSS feed and get loads more!